Auto Glanz F3 - For the highest gloss

With Auto Glanz F3 you get a fine polishing agent that helps you give the clear coat the highest possible shine. The product can be used after rougher polishing to remove holograms or simply to prepare the paint for a new seal or coating. In F3, a lot has been done to give the product a nice "slip". That is that the drying is absolutely phenomenal. The product is water-based. That is it contains no fillers. What you see is what you get!

Yum!

Auto Glanz H3 followed by F3.... A super cool setup for a 2-step polishing, where you first remove the scratches and then polish the paint to a high-gloss finish.

F3 is one of the absolute best finish polishes on the market. It does what we just want it to be able to do. In other words, just remove some holograms from rougher polishing and make the paint look COMPLETELY sharp!

It is also a good tool for you who touch the car a lot and who maybe 2-3 times a year throw a fresh wax on the car. Here, F3 will help you remove old sealing and prepare the paint for a fresh layer. And then you have the advantage that the paint will be razor sharp every time you do it!

"Drop"

F3 has a built-in special release. That is that when you have polished what you want, it is incredibly easy to wipe off again. And if there is something that is important in a finishing process, it is being able to wipe off the finishing polish easily. Because if you mess with it too much, it's easy to scratch the paint again.

It must be tried!

Recommended discs for Auto Glanz F3:

• Auto Glanz Medium One-Step Pad
• Auto Glanz Soft Finish Pad

Instructions:

• Prepare the paint for polishing. We recommend our preparation package.
• Be sure to work in the shade and on cooled panels.
• Shake the bottle thoroughly before use

1. Apply 3-4 drops of F3 to the desired polishing wheel
2. Spread the product on a plate section of max. 30x30 cm at low speed
3. Increase the speed of the machine to 3/6 and run the machine without pressure
4. Work in 50% overlapping movements while moving the machine at 3-4 cm per second.
5. Make sure to come over the same place 4-6 times in the process.
6. Wipe and inspect the area
7. Repeat points 1-6 again if necessary